Fault finder: Set-reset latch from two gates

9 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Both LEDs lit: what should I check?

Check the cross links and the pin numbers.

Latch does not hold: what should I check?

A button input is floating, check the pull-downs.

Chip hot: what should I check?

Check the supply is not above 6 V.

LEDs dim: what should I check?

Normal at 1 kilohm with a CMOS output.

Odd behaviour: what should I check?

Check unused inputs are tied to ground.