Fault finder: Automatic fading night light

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Strip is always on: what should I check?

The LDR divider is upside down or the gate pull-down is missing.

Strip flickers: what should I check?

Join the grounds, and lower the 0.02 filter value for a slower response.

Nano resets when the strip turns on: what should I check?

Poor ground or too much current, use a shorter strip.

Fuse blows: what should I check?

The strip is too long or the wiring shorts, check before replacing the fuse.

MOSFET gets hot: what should I check?

Make sure it is the logic-level IRLZ44N and the strip current is low.