Fault finder: Machine control panel with Nextion
10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Display does nothing: what should I check?
Check TX and RX are crossed and the baud rate is 9600.
Touch events missing: what should I check?
Set Send Component ID on each component.
Garbled text: what should I check?
Make sure each command ends with three 0xFF bytes.
Display reboots: what should I check?
Use its own 5 V supply.
