Fault finder: Ring-shaped focus timer

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Ring stays dark: what should I check?

Check the DIN wire goes to the IN side, not OUT.

Wrong colours: what should I check?

Change NEO_GRB to NEO_RGB for your ring.

First LED flickers: what should I check?

Add the resistor and the capacitor.

Timer too slow to test: what should I check?

Set TIME_SCALE to 60.

Ring restarts by itself: what should I check?

Power is weak, lower the brightness or use a better supply.