Fault finder: Touch switch with a 555

8 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never lights: what should I check?

Moisten your finger and press harder, or move the pads closer.

LED stays on: what should I check?

Check pin 4 goes to plus and that pins 6 and 7 are joined.

LED flickers: what should I check?

Add the 100 nF capacitor on pin 5.

Very short flash: what should I check?

Check the capacitor value and the 100 kohm resistor.

Chip hot: what should I check?

Wrong supply connection, disconnect the battery at once.