Fault finder: Charge pump voltage doubler

6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output only 4.4 V: what should I check?

Check the pump capacitor and the D9 wire.

Output near 0: what should I check?

Check diode direction, stripe to the output side.

Capacitor feels warm: what should I check?

Disconnect, it may be the wrong way round.

Reading falls fast: what should I check?

A meter on a low range loads the circuit, use the DC volt range.

Upload fails: what should I check?

Choose the Old Bootloader option.