Fault finder: Nano ADC versus ADS1115

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

ADS1115 not found: what should I check?

Check the I2C wires, the power and ADDR on GND.

Readings far off the meter: what should I check?

Check the pot's middle leg goes to A0 on both.

Nano reading is higher than the meter: what should I check?

The 5V rail may be below 5.00 V.

Negative ADS1115 values: what should I check?

Check the wiring of A0 and GND.

Library errors: what should I check?

Install Adafruit ADS1X15 and Adafruit BusIO.