Fault finder: Mushroom grow room humidity keeper

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Mist never starts: what should I check?

Check the relay logic and the 5 V supply.

Humidity never reaches the target: what should I check?

The tent leaks air or the mist maker is too small.

Reading stuck at 100: what should I check?

The sensor is wet; move it away from the mist.

LCD blank: what should I check?

Try address 0x3F.