Fault finder: Tilt-controlled LED ball

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Dot never moves: what should I check?

Check the SDA and SCL wires and that the sensor is awake.

Dot goes the wrong way: what should I check?

Change SWAP_XY, INVERT_X or INVERT_Y.

Matrix blank: what should I check?

Check DIN, CLK and CS.

Dot drifts when flat: what should I check?

Increase the dead zone from 0.08.

Dot jumps over a wall: what should I check?

Lower the 0.4 speed factor.