Fault finder: Digital spirit level with MPU6050

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Screen blank: what should I check?

Check the OLED address (0x3C or 0x3D) and the shared bus wires.

All readings 0: what should I check?

The MPU6050 did not wake. Check its address with an I2C scanner (0x68, or 0x69 if AD0 is high).

Not zero on a level surface: what should I check?

Normal sensor offset. Store the reading you get on a level surface and subtract it.