Fault finder: Moving average versus median filter

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Plotter shows one line: what should I check?

Check the baud rate is 115200 and the text has commas.

Reading stuck near 0 or 1023: what should I check?

Check the divider and that the 10 k is to GND.

Spike does nothing: what should I check?

Check the button goes to D2 and GND.

Lines look the same: what should I check?

Turn the knob up and press the spike button.

Plotter is empty: what should I check?

Close and reopen the Serial Plotter after the upload.