Fault finder: MOSFET as a switch
7 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Fan does not run: what should I check?
Check the pins and that the source is on ground.
Fan runs weakly: what should I check?
The gate is not fully driven. Check the button and 220 Ω and the supply.
Fan keeps running after release: what should I check?
The pull-down is missing so the gate floats.
MOSFET hot: what should I check?
It is not fully on, or the fan draws too much current. Check the load rating.
