Fault finder: MOSFET motor speed control lab
7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Motor does not turn: what should I check?
Check the battery, the diode direction and that the drain goes to the motor.
Motor runs all the time: what should I check?
The gate pulldown is missing, so add the 10 k from gate to ground.
MOSFET is hot: what should I check?
It is not fully on with 5 V, so use a logic-level MOSFET like the IRLZ44N or a smaller motor.
Uno resets when the motor starts: what should I check?
Power the motor from the battery, not the Uno, and add a 100 uF capacitor across the motor.
Motor only hums at low duty: what should I check?
That is normal, the dead band hides it.
