Fault finder: Model lighthouse
13 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Lamp never turns on: what should I check?
Check the LDR divider and try raising DARK_BELOW.
Lamp flickers at dusk: what should I check?
Widen the gap between the two thresholds.
Servo jitters or the Nano resets: what should I check?
The load is too heavy, use a lighter servo load or a separate 5V supply.
Lamp turns off by itself: what should I check?
Its own light is reaching the LDR, shield the sensor.
Sweep never changes speed: what should I check?
Check the pot middle leg goes to A1.
