Fault finder: Model Ferris wheel
11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Motor only buzzes or shakes: what should I check?
Check the pin order IN1 to IN4 matches the code.
Wheel does not turn: what should I check?
Check the 5 V supply is on and the ground is joined with the Nano.
Wheel is too fast: what should I check?
Lower MAX_SPEED in the code.
Motor gets warm: what should I check?
Normal for this motor, switch it off when you are not watching.
Wheel wobbles: what should I check?
Centre the card on the shaft and keep it light.
