Fault finder: Rain wiper for a model car

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Arm always wipes: what should I check?

Raise DRY_LIMIT above your dry reading.

Arm never moves: what should I check?

Check the servo signal on D9 and the shared ground.

Servo twitches or the Nano resets: what should I check?

Power the servo from a separate 5 V supply with a shared ground.

Readings jump: what should I check?

Dry the board and keep wires still.

Sensor corrodes: what should I check?

Dry the board after each test and power it only while testing.