Projects / Model cable car / Fault finder

Fault finder: Model cable car

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Car goes the wrong way: what should I check?

Swap the motor wires or AIN1 and AIN2.

Car does not move: what should I check?

Check VM has battery power and STBY is on 5V.

Fault message each time: what should I check?

Check the limit switch wiring and that the car presses it.

String slips on the pulley: what should I check?

Add a turn or roughen the pulley.

Nano resets: what should I check?

Keep the motor on its own battery and share only the ground.