Projects / Model boom gate / Fault finder

Fault finder: Model boom gate

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Gate never opens: what should I check?

Turn the sensor's small knob until its light shows a detection.

Gate opens at once: what should I check?

A sensor may see the table, adjust its range.

Gate closes on the car: what should I check?

Increase CLEAR_DELAY.

Servo twitches: what should I check?

Use a lighter boom.

Sensor light does not change: what should I check?

Check its 5V and GND wires.