Fault finder: MKR WiFi 1010 light page

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Stays silent: what should I check?

Check the name and password, and that the network is 2.4 GHz.

Reads zero or 65535: what should I check?

Check SDA and SCL on pins 11 and 12 and the 3.3 V power.

Page does not open: what should I check?

Use the exact address from the Serial Monitor and the same Wi-Fi.

Does not compile: what should I check?

Install the WiFiNINA and BH1750 libraries and the SAMD board package.

Number jumps: what should I check?

Light flickers from mains lamps and screens, this is normal.