Fault finder: Night visitor counter

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No counts: what should I check?

Wait 30 seconds after power-up and check OUT is on D2.

Too many counts: what should I check?

Raise IGNORE_MS, and keep the sensor away from heat sources and moving plants in wind.

Blank screen: what should I check?

Check A4 and A5 and the OLED address.

Wrong time: what should I check?

Reflash once with the computer clock correct.

Counts reset at power-up: what should I check?

The EEPROM magic byte was overwritten, run once more and leave it powered.