Fault finder: Milliohm meter with 4-wire sensing
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Unsteady reading: what should I check?
Keep the clips firm and away from drafts.
Always out of range: what should I check?
Check the part is under 2 ohms.
Reads zero: what should I check?
Check the force leads carry current.
