Fault finder: Microphone noise floor and gain lab

6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Mean is near 0 or 1023: what should I check?

Check the OUT wire goes to A0 and the module has power.

Reading never changes: what should I check?

Turn the gain up a little.

Signal clips at the top: what should I check?

Turn the gain down.

Very large noise: what should I check?

Keep the wires short and away from the USB lead.

Serial text is garbled: what should I check?

Set the monitor to 9600 baud.