Fault finder: Electret microphone preamp

6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output stuck at 5 V or 0 V: what should I check?

Check the supply pins and the half-supply divider.

No response to sound: what should I check?

Capsule is wired backwards. Swap its terminals.

Very noisy: what should I check?

Add the 100 nF capacitor close to the chip and keep wires short.

Clipping all the time: what should I check?

Lower the gain by reducing the 100 kΩ resistor.