Projects / Tap tempo metronome / Fault finder

Fault finder: Tap tempo metronome

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Tempo drifts: what should I check?

Remove any delay() added to the sketch. The scheduler adds the beat length to nextBeat, so it should not drift.

The knob is jumpy: what should I check?

Add 10 nF between CLK and GND, or use a better encoder.

Tap tempo is not close: what should I check?

Tap at least four times and keep steady.

No click: what should I check?

Use a passive buzzer on D8. An active buzzer only plays one tone.