Fault finder: Meshtastic mesh node for treks
6 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Flasher cannot find the board: what should I check?
Use a data USB cable and Chrome.
No messages: what should I check?
Check both nodes use the same region and channel key.
No GPS fix: what should I check?
Go outdoors and wait a few minutes.
Battery drains fast: what should I check?
Lower the position update rate.
