Fault finder: Scrolling message board
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Nothing lights: what should I check?
Check VCC, GND and the DIN side of the first module.
Text mirrored: what should I check?
Switch HARDWARE_TYPE to GENERIC_HW or PAROLA_HW.
Garbled text: what should I check?
Check CLK and CS wiring on every module.
Display dims or resets: what should I check?
Too much current from USB, lower the brightness.
Serial text does not appear: what should I check?
Set the monitor to newline and 9600 baud.
