Fault finder: Marble run lap timer

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Times look far too small: what should I check?

A sensor is picking up the track, turn its knob down.

Never starts: what should I check?

Turn the start sensor's knob up and aim it at the marble's path.

Starts but never finishes: what should I check?

Check the finish sensor's wiring to D3.

Blank screen: what should I check?

Check the OLED wires and try address 0x3D.

Speed looks wrong: what should I check?

Check TRACK_M matches the distance between the gates.