Fault finder: Marble run with motor lift

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Motor never starts: what should I check?

Check the gate wire and the battery.

Counts twice per marble: what should I check?

Add a longer debounce or move the sensor.

Counts nothing: what should I check?

Adjust the sensor's potentiometer and check OUT on D3.

Nano resets when the motor starts: what should I check?

Put a 100 µF capacitor across the motor and keep wires short.