Fault finder: Manchester code lab
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Nothing prints: what should I check?
Check the data wire, the shared ground and that both sketches are uploaded.
Only question marks: what should I check?
BIT_US must match exactly on both boards.
Letters are wrong: what should I check?
Check the wires are short and firm.
Garbled after a long time: what should I check?
Reset both boards.
Upload fails: what should I check?
Choose the Old Bootloader option.
