Projects / Magnet pole finder / Fault finder

Fault finder: Magnet pole finder

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Neither end lights the LED: what should I check?

Try the other face of the sensor or a stronger magnet.

LED always on: what should I check?

Check the output is on D2 and the pin order is right.

Sensor gets hot: what should I check?

Disconnect, the power pins may be swapped.

Both ends seem to work: what should I check?

Your sensor may be a latching or bipolar type.

No serial text: what should I check?

Set 9600 baud.