Fault finder: Magic 8-ball
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No reaction to shaking: what should I check?
Check the MPU6050 on 0x68 and lower the 0.8 threshold.
Triggers by itself: what should I check?
Raise the threshold, or check for a loose wire.
Display blank: what should I check?
Try address 0x3F, or turn the contrast screw.
Same answer often: what should I check?
Leave A0 floating for the random seed.
Sensor not found: what should I check?
Use the I2C scanner project to check the bus.
