Fault finder: 3.3 V and 5 V logic levels lab

5 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Garbage text: what should I check?

Check the baud rate on both ends and the grounds.

No data: what should I check?

Check the RX and TX are crossed.

ESP32 hot or resets: what should I check?

Disconnect and recheck the divider.

Shifter dead: what should I check?

Check the LV and HV supplies.