Fault finder: Logic analyser from a Pico

5 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

PulseView does not see the Pico: what should I check?

Check the firmware version and the driver name from the README.

Decoded data is garbage: what should I check?

Check the baud rate and the sample rate.

Nothing captured: what should I check?

Check the trigger settings and the ground wire.

Pico gets hot: what should I check?

Disconnect, a probe is on too high a voltage.