Fault finder: Livestock shed heat index

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Sensor read failed: what should I check?

Check the data wire on GPIO4 and the pull-up resistor.

No light: what should I check?

Check the LED leg direction and the resistors.

Index looks high: what should I check?

Keep the sensor out of the sun and away from hot walls.

Both lights on: what should I check?

The index is on a boundary, wait for the next reading.

Temperature reads too high: what should I check?

Keep the sensor away from the ESP32 and any heat.