Fault finder: Litter tray visit counter

13 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Counts nothing: what should I check?

Check TRIG and ECHO and that the entrance is wider than the sensor's beam.

Counts without a visit: what should I check?

Check nothing is near the baseline path and raise MARGIN_CM.

Empty distance shows 400: what should I check?

The sensor sees no echo, check wiring and aim.

Blank screen: what should I check?

Check the OLED wires and try address 0x3D.

Count wrong after a power cut: what should I check?

The count is not saved, reset it.