Fault finder: Lissajous figure drawer

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Blank screen: what should I check?

Check the OLED wires and try address 0x3D.

Figure jumps between shapes: what should I check?

Knobs jitter at a boundary, so nudge them to the middle of a step.

Slow drawing: what should I check?

Keep Wire.setClock(400000) and lower POINTS.

Figure is not closed: what should I check?

Both knobs must give whole numbers, which map() does.

Upload fails: what should I check?

Choose the Old Bootloader option for the Nano.