Fault finder: Light level dashboard

11 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always 0: what should I check?

The divider middle is not on GPIO34, or the 10 kΩ goes to 3V3 instead of GND.

Always 4095: what should I check?

LDR and resistor swapped is fine (inverted), but 4095 means a short to 3V3.

Readings jump: what should I check?

Average more samples, and keep wires short.