Fault finder: LED ring wheel of fortune

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Ring stays dark: what should I check?

Check the arrow on DIN, 5V and GND.

Wrong colours: what should I check?

Change NEO_GRB to NEO_RGB.

Nano resets: what should I check?

Lower the brightness number and use a better USB port.

First LED flickers: what should I check?

Check the resistor is on the data wire.

Always stops at the same LED: what should I check?

Check the analog pin A0 is not wired to anything.