Fault finder: Warm-to-cool desk lamp

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Both strips glow when off: what should I check?

Gate pull-down resistor missing.

Strip flickers: what should I check?

Check the 12 V connections and that the grounds are common.

One strip is always dim: what should I check?

Check the MOSFET orientation and the gate resistor.

Nano gets hot: what should I check?

Feed it from a 5 V buck converter instead of VIN.