Fault finder: 3×3×3 LED cube
7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
A whole layer stays dark: what should I check?
Check its transistor, base resistor and cathode joint.
A column never lights: what should I check?
Look for a cold joint on its anode legs.
Two layers show the same picture: what should I check?
Check no cathode square touches another layer.
Brightness varies: what should I check?
Check the LEDs are the same colour and batch.
