Fault finder: Sound-reactive LED costume
6 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
LEDs flicker: what should I check?
Check the common ground and the 330 ohm resistor.
Always full: what should I check?
Lower the gain screw or raise the 400.
Reboots on bass: what should I check?
The bank cannot give enough current; lower brightness.
