Fault finder: Battery level bar graph

11 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No LEDs at all: what should I check?

Check the chip's V+ and ground and orientation.

All LEDs always on: what should I check?

Pin 5 is above the top reference. Lower the signal divider.

Steps wrong: what should I check?

Re-adjust both potentiometers while watching pin 4 and pin 5 with the meter.

Chip hot: what should I check?

Bar mode for a long time. Use dot mode or only press the button briefly.