Fault finder: Leaf wetness sensor for disease warning

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always wet: what should I check?

Combs touching, or flux or dirt bridging the tracks; clean with isopropyl alcohol.

Never wet: what should I check?

Threshold too high, or the drive pin is not connected.

Readings creep up over days: what should I check?

Corrosion; replace the comb and lacquer it.

No SD lines: what should I check?

Card format or CS pin; the sketch carries on without it.

Wrong day totals: what should I check?

Set the RTC with the RTClib example first.