Fault finder: Sunrise wake-up lamp
11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No RTC found: what should I check?
Check SDA, SCL and power on the clock module.
Wrong time: what should I check?
Upload once so the clock is set, then check the coin cell.
Fade looks like steps: what should I check?
Check the gamma line and the PWM pins.
Lamp always dim: what should I check?
Check the LDR divider, the room reading may be above the threshold.
Pin or LEDs warm: what should I check?
Check each LED has its own 220 ohm.
