Fault finder: Parallel LCD wiring primer

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Blank screen: what should I check?

Turn the pot slowly and check pins 1, 2 and 3.

Dark boxes only: what should I check?

Check E, RS and the four data wires.

Garbled text: what should I check?

A data wire is on the wrong pin.

No backlight: what should I check?

Check pins 15 and 16 and the resistor.

Text on one line only: what should I check?

Check lcd.begin(16, 2).