Projects / LCD menu system / Fault finder

Fault finder: LCD menu system

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Menu moves two steps per click: what should I check?

Some encoders give two edges per detent. Use only the falling edge as in the code.

Direction reversed: what should I check?

Swap the CLK and DT wires.

Values do not save: what should I check?

Press the button to finish editing. Saving happens on exit.

LCD blank: what should I check?

Check the address and the contrast trimmer.