Fault finder: Solder your own LCD backpack
9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Scanner finds nothing: what should I check?
Check SDA and SCL are on A4 and A5.
Only blocks show: what should I check?
Turn the contrast trimmer.
Garbled text: what should I check?
Check for a solder bridge or a bad joint.
Wrong address: what should I check?
Use the address from the scanner.
Backlight off: what should I check?
Check the jumper on the backpack.
