Fault finder: Four-line to-do board

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Blank screen: what should I check?

Try address 0x3F and adjust the contrast screw.

Only boxes show: what should I check?

Contrast is too high or too low.

Button needs two presses: what should I check?

Check the wiring to GND.

Text is cut off: what should I check?

Keep each job to 16 letters.

Ticks not remembered: what should I check?

Check the EEPROM lines were not removed.