Fault finder: Two-motor bump robot

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

One wheel backwards: what should I check?

Swap that motor's two wires.

Motors do not turn: what should I check?

Check pin 8 has battery power and the grounds are joined.

Nano resets when motors start: what should I check?

Weak battery or shared supply, use a stronger battery.

Chip gets hot: what should I check?

Motors stalled or drawing too much, check the wheels spin freely.

Robot turns the wrong way on a bump: what should I check?

Swap the BUMP_L and BUMP_R pins.