Fault finder: Real-time object detection on Jetson Orin Nano

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

failed to create videoSource: what should I check?

The camera is not detected. Reseat the ribbon with the power off and check nvgstcapture first.

Very low FPS: what should I check?

The first run is building the engine. Later runs start fast. Set the power mode with nvpmodel.

No window over SSH: what should I check?

Use videoOutput("rtp://<laptop-ip>:1234") or "webrtc://@:8554/output" and view it on your laptop.

Gets hot: what should I check?

Keep the fan connected and the heatsink clear. See the Jetson power and thermal lesson.